Woodstock SHOP FOX W1755 - Manual (Page 15)

-13-
W1755 6" Parallelogram Jointer
SE
TU
P
To assemble the jointer, do these steps:
1. Carefully lay the stand on its side so you can access
the underside.
2. Use the M8-1.25 x 50 hex bolt and 8mm flat washer
to bolt the wheel assembly to the stand, as shown in
Figure 9.
3. Use the two M10-1.5 x 55 hex bolts, 10mm flat
washers, and M10-1.5 hex nuts to finish tightening
the wheel assembly to the stand, as shown in Figure
10.
4. Turn the stand rightside up and remove the back
cover.
Assembly
Figure 9. Bolting wheel assembly to stand.
Figure 10. Securing wheel assembly to
stand.
Figure 11. Securing the jointer to the
stand.
The jointer is very heavy. The
next step requires two strong
people or power lifting equipment
to lift the jointer.
5. Lift the jointer onto the stand and align the mount-
ing holes.
6. Use the provided four M8-1.25 x 25 cap screws and
8mm lock washers to secure the jointer to the stand,
as shown in Figure 11.