Woodstock SHOP FOX W1755 - Manual (Page 24)

-22-
W1755 6" Parallelogram Jointer
O
PE
R
AT
IO
N
S
Squaring Stock
Squaring stock involves four steps performed in the order
below:
1. Surface Plane on the Jointer: The concave face of
the workpiece is surface planed flat with the jointer
( Figure 32).
2. Surface Plane on a Thickness Planer: The opposite
face of the workpiece is surface planed flat with a
thickness planer ( Figure 33).
3. Edge Joint on the Jointer: The concave edge of the
workpiece is jointed flat with the jointer ( Figure
34).
4. Rip Cut on a Table Saw: The jointed edge of the
workpiece is placed against a table saw fence and
the opposite edge cut off ( Figure 35).
Figure 32. Surface plane on the jointer.
Figure 34. Edge joint on the jointer.
Figure 33. Surface plane on a thickness
planer.
This Side Previously
Surface Planed
�� ��
��
Figure 35. Rip cut on a table saw.
This Side
Previously Edge
Jointed