Sprint Nextel 2.4 GHz Digital Spread Spectrum Dual Keypad Cordless Phone with Caller ID/Call Waiting - Manual (Page 14)

14 Telephone Operation
SELECTING THE CHANNEL
The phone has 30 channels. If the call
seems to disconnect for no reason during a
call, press
SELECT/CHANNEL on the handset
to select a different channel. Scanning ap-
pears while your phone searches for a clear
channel.
ADJUSTING THE HANDSET
VOLUME
To adjust the handset’s volume during a call,
press
VOL/CID
8 8 8 8
or
9 9 9 9
until you reach the
desired volume level. Volume Maximum ,
Volume High , Volume Medium , or
Volume Low appears.
The setting is maintained even after you
hang up the phone.
Note: When you press VOL/CID
8 8 8 8
while the
volume is maximum or
9 9 9 9
while the volume
is low, the setting does not change and the
phone beeps three times.
USING THE
SPEAKERPHONE
To make or answer a call using the speaker-
phone, press
SPEAKER . The SPEAKER indi-
cator lights. When you hear a dial tone, dial
the number.
To set the speakerphone's volume, slide
VOLUME on the right side of the base.
To end a speakerphone call, press SPEAKER
again.
Switching Between the Handset
and Speakerphone
To switch to the speakerphone while you are
using the handset, press
SPEAKER on the
base. When you hear the conversation or
dial tone on the speakerphone, press
TALK
on the handset.
To switch to the handset while you are using
the speakerphone, simply lift the handset off
the base. If the handset is away from the
base, press
TALK , then press SPEAKER .
Using Both the Handset and
Speakerphone
If someone else is using the speakerphone,
press
TALK on the handset to join the con-
versation.
If someone else is using the handset, press
SPEAKER on the base to join the conversa-
tion.
During the call, one person can hang up and
let the call continue at the other keypad.
Or, both people can hang up at the same
time to end the call.
Note: If you hear a high-pitched noise from
the base's speaker, the handset and the
base are too close together.
USING REDIAL
You can quickly dial any of the last three
numbers you dialed on the handset. Lift the
handset and repeatedly press
RDL/PAUSE
until the number you want to dial appears.
Then press
TALK and the phone dials the
number.
You can also dial the last number dialed us-
ing the speakerphone. Press
SPEAKER then
REDIAL/PAUSE on the base.
Notes:
• The redial memory for each keypad is
separate. You cannot redial a number
you dialed on the handset’s keypad
using
REDIAL/PAUSE on the base’s key-
pad, and vice versa.
43-5522.fm Page 14 Tuesday, September 12, 2000 3:12 PM