Seagate MEDALIST PRO ST36530N/W/WC - Manual (Page 48)

46 Medalist Pro Installation Guide, Rev. B
W/LW drives
W/WD drives section Setting the SCSI ID jumpers
Use the J6 jumper block to set the SCSI ID (Figure 11). To
change the SCSI ID, install jumpers on the appropriate pins as
shown in the illustration. Optional connections to switching cir-
cuits in host equipment are provided on J1 auxiliary to set the
SCSI ID (see Figure 12).
Figure 11. Setting the SCSI ID on model W/LW drives
A2 A3 A1 A0
SCSI ID = 0 (default)
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
Reserved
L
E
D
R
E
S
SCSI ID = 8
SCSI ID = 9
SCSI ID = 10
SCSI ID = 11
SCSI ID = 12
SCSI ID = 13
SCSI ID = 14
SCSI ID = 15
Jumper Plug
(enlarged to
show detail)
J6
Drive
Front
Pin 1