Scotts S2048 - Manual (Page 56)

Service Mower - Page 52
SERVICE MOWER
Servicing Mower Blades
REMOVING MOWER BLADES
1. Raise mower deck to gain access to mower blades. If
necessary, remove mower deck.
2. Use a wooden block to prevent mower blades from
spinning.
3. Remove cap screw (A), round blade washer (B),
blade (C) and deflector cup (D).
4. Inspect blades; sharpen/balance or replace as
necessary.
INSTALLING MOWER BLADES
1. Lightly lubricate cap screw threads with a general
purpose grease or oil to prevent rusting and seizing.
2. Install deflector cup (D) on spindle.
3. Position mower blade (C) with the cutting edge
towards the ground onto the mower spindle.
4. Install blade washers (B) and make sure 2 index
marks (E) are visible when installed.
5. Install and tighten cap screw (A) by hand until mower
blade is in full contact (fully seated) with spindle.
6. Block mower blade to prevent spinning. Tighten cap
screw (A) to 68 N•m (50 lb-ft).
c
CAUTION: Avoid injury. Mower blades have
sharp edges. Always wear gloves when
handling mower blades.
IMPORTANT: Avoid machine damage. Some blade
washers (B) have two index marks (E). When
these blade washers are installed, the index
marks must be visible. This will indicate that the
cup side of the washer is toward the blade (C).
M88116
A
B
C
D
M88112C
D
C
M88127A
E
B
C
A