Scotts S2048 - Manual (Page 78)

Troubleshooting - Page 74
TROUBLESHOOTING
Requires High Effort To Lift And Latch Lift
Handle Front draft arm on mower is adjusted too short, causing
lift system to bind up.
Patches Of Grass Uncut Travel speed too fast.
Engine rpm too low.
Belt Slipping Debris in sheaves.
Worn belt.
Too Much Vibration Debris on mower deck or in sheaves.
Damaged drive belt.
Damaged sheaves or sheaves out of alignment.
Blades out of balance.
Blades Scalping Grass Cutting too low.
Turning speed too fast.
Ridges in terrain.
Rough or uneven terrain.
Low tire pressure.
Mower gauge wheels not adjusted correctly.
Bent blade(s).
Uneven Cut Mower not level.
Travel speed too fast.
Blades dull.
Mower gauge wheels not adjusted correctly.
Tire pressure.
Mower Loads Down Tractor Engine rpm too low.
Travel speed too fast.
Debris wrapped around mower spindles.
Bagging blades on mower.
Grass Tips Are Jagged And Turn Grayish
Brown After Mowing Dull mower blades.
Bent blades.
Front-to-rear blade adjustment not set properly.
IF CHECK