SanDisk Wireless LAN Card - Manual (Page 13)

Page 9
Install the Wireless LAN Card
Insert the Wireless LAN Card into the CompactFlash® slot of your Pocket PC.
The Pocket PC will automatically detect the card and install the correct driver
and utility.
The Wireless LAN Card has a green LED indicator.
When the LED is steady green, the Wireless LAN Card has successfully
connected to an access point or to computer that is not connected to a
wired network (Ad-Hoc mode).
When the LED is blinking the Wireless LAN Card is not connected to an
access point or the Power Save mode has been enabled.
Assign an IP Address
On the Start window of the Pocket PC you set the Wireless LAN Card to
automatically obtain an IP address from your DHCP server. The Internet
Protocol (IP Address) is an identifying number assigned to all network devices.
The default setting is Use server-assigned IP address. To use a specific IP
address, refer to CONFIGURING THE WIRELESS LAN CARD FOR USE WITH
THE POCKET PC.
When an IP address has been
detected, the Wireless LAN Card will
look for an access point. The green LED
on the card will blink until an access
point is located. Once the Wireless LAN
Card locates an access point, the green
LED will remain steady.