Sharp VL-NZ50U - Manual (Page 31)

18
Basic Operations
Remaining Battery
Power Display
When using the camcorder with the battery
pack as the power source, the remaining
battery power indicator is displayed. If the
battery power becomes very low, a warning
indicator appears. Replace the battery pack.
Notes:
• The remaining battery power indicator
appears when the on-screen indicators turns
on.
• Use the remaining battery power indicator only
as an approximate indication.
• The remaining battery power indicator may
change to either a higher or lower level if you set
the Power switch to OFF and then back to
CAMERA or VCR.
• In cold environments, the red remaining battery
power indicator may appear sooner.
• Use of the zoom functions when the warning
indicator is displayed may cause the camcorder
to suddenly lose power.
The tape has reached
the end.
T HE
E NDS SOON.
T A P E
T A PE E ND
CHANGE T HE
CAS SE T T E .
T A PE E ND
Warning indicator Approx. remaining time
Less than 1 min.
3 0 min
BA T T E RY I S
T OO LOW.
Remaining Recording
Time Display
When the camcorder is recording, an on-
screen indicator displays the approximate
remaining tape time in minutes.
Notes:
• The remaining recording time indicator
appears when the on-screen indicators turns
on.
• The remaining recording time indicator
appears 10 seconds after pressing the REC
START/STOP button to begin recording.
• The remaining recording time indicator only
shows the approximate time left. Also, it varies
slightly depending on the length of tape used.
(This function is based on the DVM60 tape
standard.)
When the remaining recording time reaches 1
minute, a warning indicator will appear.
Prepare a new cassette.
(Green)
Remaining recording
time indicator
Warning indicator
(Green)
(Red)
Remaining battery
power indicator
VL-NZ50U-016-021 02.2.12, 5:20 PM 18