Sinclair Mambo Surface Prep - Manual (Page 6)

Use:
- Mount discs or brushes as described above.
- Put the handle in working position with the
big lever (1) at the back.
- We recommend to position the hand grip to
the height of the users hip.
- Lift the handle slightly, to make sure the
machine stands horizontally.
- Keep the safety switch (2) pressed.
- Switch on the machine with one of the levers
(3) located beneath the grip.
- Release switch (2).
Note: lever can only be actuated, if the handle
is not in vertical position. This is a safety
feature! The user cannot control the machine
with the vertical handle. After switching on
the machine, the handle will move shortly to
the right.
If the transportation wheels are in lifted
position, the direction in which the machine
moves, is controlled by lifting or lowering
the grip. The more you lift or lower the
grip, the faster the machine runs to the
corresponding direction.
- Lifting the machine: machine runs to the right.
- Lowering the machine: machine runs to the left.
If you feel unsafe or cannot control the machine, just release lever (3). The machine will stop
at once. If you have carried out some training, you will be able to operate the machine with
one hand.
If the transportation wheels are lowered to the floor, the machine is stabilized and easier to
control.
- Lifting and lowering of the handle is no more necessary.
- The machine has to be in a level position. The wheels have to be fixed accordingly.
By loosening the release handle (5), the wheels can be put in upper and lowered position.
Speed control:
Adjust the speed of the discs with switch (4).
Turning clock-wise increases the speed,
turning anti-clockwise decreases the speed.
The optimal speed is dependent on the disc
used and the sub-floor.
6