Sinclair Mambo Surface Prep - Manual (Page 8)

Mounting or changing the paper bags of the Vacuum Micropac Unit
Paper bags are used for the vacuum unit Micropac.
Replacement paper bags, 20 piece, Item # M13498.
- Release the 2 snap fasteners (B) and
remove lid (C).
- Ensure inner cloth filter is clean.
- Ensure rubber molding (D) is firmly
fitted around top rim of container.
- Gently open new dust bag and place in
vacuum container. Slide flange (A) of
the dust bag over inlet spigot (E) until
secure.
- Replace and secure lid with 2 snap
fasteners.
To facilitate the removal of a full dust bag, tube (E) may be withdrawn from the
vacuum unit container having firstly removed elbow connector (F).
7.0 Troubleshooting
Trouble Eventual
Cause Elimination
Machine does not start Power supply disconnected
Blown fuse
Defective cable or plug Have a machine repaired by
a qualified electrician,
resp. change parts
Switch-on lever cannot be
actuated Safety lever can only be actuated,
if handle not vertical Lower the handle of the
machine
Machine stops Lamp flashes fast
Overload protection responds Power plug disconnect
Wait some minutes
Switch the machine on again
8.0 Schematic/Parts List
Schematic # Pieces Description Part #
1 1 Housing 017830
2 1 Disc cover 037933
8