SMC Networks SMC2555W-AG - Manual (Page 82)

System Configuration
5-26
CLI Commands for SNMP – Use the snmp-server enable
server command from the global configuration mode. To set
read/write and read-only community names, use the
snmp-server community command. Use the snmp-server
location and snmp-server contact commands to indicate the
physical location of the access point and define a system contact.
The snmp-server host command defines a trap receiver host. To
view the current SNMP settings, use the show snmp command.
SMC-AP(config)#snmp-server enable server 6-37
SMC-AP(config)#snmp-server community alpha rw 6-35
SMC-AP(config)#snmp-server community beta ro
SMC-AP(config)#snmp-server location WC-19 6-39
SMC-AP(config)#snmp-server contact Paul 6-36
SMC-AP(config)#snmp-server host 10.1.19.23 alpha 6-38
SMC-AP(config)#exit
SMC-AP#show snmp 6-40
SNMP Information
============================================
Service State : Enable
Community (ro) : ****
Community (rw) : *****
Location : WC-19
Contact : Paul
Traps : Enabled
Host Name/IP : 10.1.19.23
Trap Community : *****
=============================================
SMC-AP#