Solid State Logic XLOGIC 82S6XL010D - Manual (Page 13)

Page 9
Appendix A – Internal links and fuses
Fuses (Mains Inlet)
The mains inlet contains a single 1 amp 1.25" time delay fuse (SSL Part No. 35FJJ310). To change it disconnect the
mains inlet, then using a small screwdriver prise open the mains selector cover. This contains the fuse. Test and
replace with the same type and value if necessary.
Internal Fuses
The internal power rails are also individually fused. These fuses should only be changed by suitably experienced
staff. They are listed below
Fuses (629610X1 Power Regulator Card)
+48V FS-1 - 500mA wire ended (SSL part No. 35F5E250)
Fuses (629601X1 Main Card)
–18V FS1 - 3 amp wire ended (SSL part No. 35F5E330)
–15V FS2 - 3 amp wire ended (SSL part No. 35F5E330)
+15V FS3 - 3 amp wire ended (SSL part No. 35F5E330)
+18V FS4 - 3 amp wire ended (SSL part No. 35F5E330)
+5V FS5 - 3 amp wire ended (SSL part No. 35F5E330)
Links
LK3 Solder link. Links chassis and analogue 0V. Do not remove.
LK4 Links 0V of input and output XLRs to chassis. Normally fitted. Remove to capacitively couple.
LK5 Solder link. Links 0VA planes. Do not remove.
LK6 Solder link. Links digital and analogue 0V. Do not remove.
LK8 Not used
LK9 Not used
LK10 Normally audio passes through VCAs at all times. Removing LK10 will switch in the bypass
relays when all compressor IN and Master Fader IN switches are off. Normally fitted.
Appendix B – Connector Details
Audio Input
Location: Rear Panel
Conn' Type: XLR Female
Pin Description
1 Chassis
2 Audio +ve
3 Audio -ve
Audio Output
Location: Rear Panel
Conn' Type: XLR Male
Pin Description
1 Chassis
2 Audio +ve
3 Audio -ve
Appendix