Solid State Logic XLOGIC 82S6XL010D - Manual (Page 7)

Page 3
Introduction
1.0 Introduction
The XLogic Multichannel Compressor is a 2U rack-mounting six-channel compressor. It utilises classic SSL
Centre Section compressor design elements within a SuperAnalogue design topology. This brings the dual
benefits of spectacular surround audio performance with a universally acclaimed compressor characteristic.
The unit contains two separate compressors. Normally the upper one controls the left, centre, right and surround
channels and the lower one the LFE channel, but the DUAL STEREO switch reassigns the controls so that the
lower set control the surround channels and the upper set control left, centre, right and LFE channels.
The SIDE CHAIN TRIM controls allow different thresholds to be set for left/right, centre, surround and LFE
channels. The centre and surround ISO switches bypass the respective compressor channels completely.
A six channel Master Fader and Autofade control provide overall level control of the mix
The object of this manual is to provide purchasers of the XLogic Multichannel Compressor unit with information
in the following areas:
• Operation of the unit
• Safety considerations
• Installation requirement
• Electrical connections and cabling
• Connector pin-outs
• Specifications and physical dimensions
Warranty
The warranty period for this unit is 12 months from date of purchase.
In Warranty Repairs
In the event of a fault during the warranty period the unit must be returned to your local distributor who will
arrange for it to be shipped to Solid State Logic for repair. All units should be shipped to Solid State Logic in their
original packaging. Solid State Logic can not be held responsible for any damage caused by shipping units in
other packaging. In such cases Solid State Logic will return the unit in a suitable box, which you will be charged
for. Please do not send manuals, power leads or any other cables - Solid State Logic can not guarantee to return
them to you. Please also note that warranty returns will only be accepted as such if accompanied by a copy of the
receipt or other proof of purchase.
Out of Warranty Repairs
In the event of a fault after the warranty period has expired, return the unit in its original packaging to your local
distributor for shipment to Solid State Logic. You will be charged for the time spent on the repair (at Solid State
Logic's current repair rate) plus the cost of parts and shipping.