SIIG 04-0600B - Manual (Page 4)

4
2. Once the proper configuration is determined, secure
the post to the speaker.
3. Some speakers use the smaller M4 x 8 screw, which is
inserted into the off-center on the mounting post, see
Figure 2 below.
4. Check the size of the hole, make sure you have the
8-32 x 5/8" machine screw, the 1/4"-20 x 1/2" machine
screw, the M6 x 20mm, or the M5 x 20mm fits inside,
see Figure 3 below.
Figure 3
Figure 2
M4 x 8mm Flat Head
Machine Screw
Back Speaker
M5 x 1/8" Plastic Washer
1/4"-20 x 1/2" Machine Screw
8-32 x 5/8" Machine Screw
Back Speaker