SIIG 04-0600B - Manual (Page 5)

5
5. When the correct size is determined, place the screw
through the speaker post and attach to the rear of the
speaker enclosure. If the screw does not tighten
properly, use the M5 x 1/8" plastic washer to tighten
it up.
Key Hole Mounting
1. If your speaker has a factory key hole design, you will
use the 8-32 x 5/8" machine screws in combination
with the 8-32 Hex Key Hole Nut.
2. Loosely pre-assemble the mounting post with the
8-32 x 5/8" machine screw and hex key hole nut, see
Figure 4 below.
M5 x 1/8"
Plastic Washer
8-32 x 5/8"
Machine Screw
Mounting Post Keyhole
Back Speaker
Figure 4
8-32 Hex Key Hole Nut