Sanyo PLC-EF60 - Manual (Page 43)

43
Computer Adjustment
Adjust this item when the projected image is affected by the
noise from the external equipment. (From 0 to 15)
V-sync phase
Reset
Mode
Exits the PC Adjust Menu.
Quit
Resets all adjustments to their previous levels.
Vacant Mode
shows the selected input,
source and system, and values
of “Fine sync,” “Total dots,”
“Clamp,” “Display area,” and
“Position.”
To store adjustment data
To clear adjustment data
Press the SELECT button
at the Display area and the
Display area dialog box
appears.
✔
Note:
Fine sync. and Display area cannot be selected when “480i”, “575i”, “480p”,
“575p”, “720p”, “1035i”, “1080i/50” or “1080i/60” is selected in the System
menu (p40).
Adjusts picture position.
Position
To store the adjustment data or clear the stored data, move the
yellow frame pointer to Mode and then press the SELECT
button.
Store
To store the adjustment data, select Store and press the
SELECT button to display Mode dialog box. Move the
yellow frame pointer to any of Mode 1 to 50 in which you
want to store and then press the SELECT button.
Free
To clear the adjustment data previously set, select Free and
press the SELECT button to display Mode dialog box. Move
the yellow frame pointer to any of Mode 1 to 50 in which
you want to clear and then press the SELECT button.
Computer Adjustment
✔
Note:
V-sync phase is not displayed as the item is initially checked off on My menu in the
Setting menu. Change the My menu setting in the Setting menu (p51) when
necessary to adjust V-sync. phase.