Sanyo PLC-EF60 - Manual (Page 12)

12
Preparation
ANALOG OUT
INPUT 3 INPUT 1
INPUT 2
ANALOG IN
DIGITAL (DVI-D) AUDIO 1
AUDIO 2
VIDEO/Y Cb/Pb Cr/Pr
G B R H/V V VIDEO/Y Cb/Pb Cr/Pr
S-VIDEO
R-AUDIO-L
(MONO)
Terminals
q
w
e
r
e INPUT 3 terminals
AUDIO (R-L)
Connect the audio output from video equipment
connected to VIDEO/Y Cb/Pb Cr/Pr jacks or S-VIDEO
jack to these jacks. (When the audio output is
monaural, connect it to L(MONO) jack. (p24, 25)
VIDEO/Y, Cb/Pb, and Cr/Pr
Connect video or component output (Y, Cb/Pb and
Cr/Pr) from video equipment to these jacks with a
video cable (RCA-type). (p24, 25)
S-VIDEO
Connect S-Video output from video equipment to this
jack. (p24)
r INPUT 2 terminals
AUDIO 2
Connect the audio output from video equipment
connected to VIDEO/Y, Cb/Pb, and Cr/Pr jacks or G,
B, R, H/V, and V jacks to this jack. (p22, 25)
VIDEO/Y, Cb/Pb, and Cr/Pr
Connect video or component output (Y, Cb/Pb and
Cr/Pr) from video equipment to these jacks with a
video cable (BNC-type). (p25)
G, B, R, H/V, and V
Connect RGB output signal from a computer with a
computer cable (5 BNC-type) to these jacks. (p22)
w ANALOG OUT
This terminal can be used for analog signal output
incoming through the ANALOG IN terminal (INPUT 1).
Connect this terminal to the other monitor with a VGA
cable. (p22)
q INPUT 1 terminals
AUDIO 1
Connect the audio output from a computer or video
equipment connected to DIGITAL (DVI-D) or ANALOG
IN terminal to this jack. (p22, 24)
DIGITAL (DVI-D) (HDCP compatible)
Connect digital output signal from a computer or
video equipment to this terminal with a DVI-D cable.
(p22, 24)
ANALOG IN
Connect analog output signal from a computer or a
video equipment (Component or RGB Scart) to this
terminal with a VGA cable, a Scart-VGA or a
Component-VGA cable. (p22)