Sanyo PLC-EF60 - Manual (Page 48)

48
Provides image to fit the horizontal size of the screen size.
When the input signal is SXGA (5:4), the image is fully displayed
at 4:3 aspect ratio.
Full screen
Adjusts aspect (scale and position) of the screen. Press the
SELECT button at "Custom". "Custom" will be displayed on the
top left of the screen for 4 seconds and then return to the
previous menu display. Press the SELECT button again with
the pointer staying on Custom to display Aspect setting menu.
Adjust each value of Scale and Position.
Scale . . . . .adjusts horizontal and vertical scale of the screen.
(From –32 to +32)
H&V . . . . . .changes Vertical value subject to Horizontal
value; when a checkmark is put on H&V, Scale V
cannot be adjusted.
Position . . .adjusts horizontal and vertical position of the
screen. (From –15 to +15)
Common . .applies the current Aspect setting to all the
Inputs.
Reset . . . . .resets all adjusted values to zero.
Quit . . . . . .exits the Aspect setting menu.
1
2
Screen Setting Menu
Wide
Provides image to fit screen size.
Normal
True
Custom (Aspect)
Provides image in its original size. When the original image size
is larger than the screen size, this projector enters panning
mode automatically. While "True" is displayed on screen, pan
the image with the Control pad. Digital zoom + and – mode can
be switched by pressing the SELECT button.
Provides image to fit wide video aspect ratio (16 : 9) by
expanding image width uniformly. This function can be used
for providing a squeezed video signal at 16 : 9.
selects the screen size from Normal, Wide, True and Full screen;
customizes it by Scale, H&V, Position, Common and Reset; adjusts it by
Digital zoom +/–, Keystone and sets Ceiling and Rear.
Screen
Press the MENU button to display On-Screen Menu. Spin
the menu icons with the Control pad and press the SELECT
button when the SCREEN SETTING icon comes right in
front.
Move the yellow frame pointer with the Control pad to an
item which you want to select.
Screen (Custom: H&V)
Screen Setting
Screen Setting
Screen (Custom)
Item data
Adjust value with
the Control pad.
Screen (Custom: Common)
Screen Setting
icon
Aspect Setting Menu
Move the pointer to an item to
set and adjust value with the
Control pad.
Pointer
Checkmark
Move the pointer to "Common" and
press the SELECT button. The
confirmation box appears. Select [Yes]
to activate it.
Pointer
✔
Note:
The adjusted aspect can basically be memorized for each input even if the projector
is turned off.