Sony STR-DA2ES - Manual (Page 46)

46 GB
Adjusting the equalizer (continued)
EQ menu parameters
x FRONT BASS XXX.X dB
(Front speaker bass level)
x FRONT MID XXX.X dB
(Front speaker midrange level)
x FRONT TREBLE XXX.X dB
(Front speaker treble level)
x CENTER BASS XXX.X dB
(Center speaker bass level)
x CENTER MID XXX.X dB
(Center speaker midrange level)
x CENTER TREBLE XXX.X dB
(Center speaker treble level)
x SURROUND BASS XXX.X dB
(Surround speaker bass level)
x SURROUND TRE. XXX.X dB
(Surround speaker treble level)
x SUR.BACK BASS XXX.X dB
(Surround back speaker bass level)
x SUR.BACK TRE. XXX.X dB
(Surround back speaker treble level)
Initial setting: 0 dB
You can adjust from –10 dB to +10 dB in 0.5 dB
steps.
To apply equalization
Press EQUALIZER. Each press turns the
equalizer on or off. The EQ indicator lights
when the equalizer is on.
For advanced EQ menu adjustments
Use the CUSTOMIZE menu and set “MENU
EXPAND” to “ON” to enable advanced
adjustments.
For details on “MENU EXPAND”, see page
46.
For details on how to set the items, see page 55.
Advanced settings
Using the CUSTOMIZE menu
to adjust the receiver
You can adjust various receiver settings using
the CUSTOMIZE menu.
1
Press CUSTOMIZE.
The CUSTOMIZE menu appears in the
display.
2
Press the cursor buttons ( or ) to
select the parameter.
For details, see “CUSTOMIZE menu
parameters” below.
3
Turn the jog dial to adjust the selected
parameter.
4
Repeat steps 2 and 3 to adjust the other
items.
CUSTOMIZE menu parameters
The initial setting is underlined.
x MENU EXPAND (Menu expanding)
• ON
The advanced parameters for the SET UP,
SURROUND, LEVEL, and EQ menus are
displayed and can be adjusted.
For details on each setup items, see pages 21, 43–45
and the following pages.
• OFF
The advanced parameters are not displayed.
x dts 96/24DEC.
(DTS 96/24 decoding mode)
• AUTO
When a DTS 96/24 signal is input, it is played back
at 96 kHz sampling frequencies.
• OFF
Even when a DTS 96/24 signal is input, it is played
back at 48 kHz sampling frequencies.
Note
This parameter is valid only in the AUTO
DECODING mode (page 34). In other sound fields,
this parameter is always set to “OFF”.