Sony STR-DA2ES - Manual (Page 52)

52 GB
Advanced settings (continued)
x FRONT SP > XXX Hz
(Front speaker crossover frequency)
Initial setting: STD (120 Hz)
Lets you adjust the front speaker bass crossover
frequency when “FRONT SP” (front speaker size) is
set to “SMALL”. You can adjust from 40 Hz to 200
Hz in 10 Hz steps.
x CENTER SP > XXX Hz
(Center speaker crossover frequency)
Initial setting: STD (120 Hz)
Lets you adjust the center speaker bass crossover
frequency when “CENTER SP” (center speaker size)
is set to “SMALL”. You can adjust from 40 Hz to
200 Hz in 10 Hz steps.
x SURROUND SP > XXX Hz
(Surround speaker crossover frequency)
Initial setting: STD (120 Hz)
Lets you adjust the surround speaker bass crossover
frequency when “SURROUND SP” (surround
speaker size) is set to “SMALL”. You can adjust from
40 Hz to 200 Hz in 10 Hz steps.
x SURR BACK SP > XXX Hz
(Surround back speaker crossover
frequency)
Initial setting: STD (120 Hz)
Lets you adjust the surround back speaker bass
crossover frequency when “SURR BACK SP”
(surround back speaker size) is set to “SMALL”. You
can adjust from 40 Hz to 200 Hz in 10 Hz steps.
x LFE HIGH CUT > XXX Hz
(LFE high cut filter)
Initial setting: STD (120 Hz)
Lets you select the cut off frequency of the LFE
channel high cut filter. Normally, select “STD
(120 Hz)”.
When using a passive sub woofer powered by a
separate power amplifier, it may be better to change
the cut off frequency. In this case, you can adjust
from 40 Hz to 200 Hz in 10 Hz steps.
Advanced SURROUND menu
parameters
When “MENU EXPAND” is set to “ON”, all
of the following parameters are displayed and
adjustable.
See page 43 for the SURROUND menu
adjustments.
Initial settings are underlined.
All SURROUND menu parameters
C.WIDTH*
DIMENSION*
PANORAMA MODE*
EFFECT
WALL*
REVERB*
FRONT REVERB*
SCREEN DEPTH*
VIR.SPEAKERS*
* Adjustable only when “MENU EXPAND” is set to
“ON”.
x C WIDTH
(Center width control)
Initial setting: (3)
Lets you perform further adjustments for Dolby Pro
Logic II Music mode decoding (PLII MUSIC). You
can set this parameter only when “2CH MODE” is set
to “PLII MUSIC” (page 38) and NORMAL
SURROUND is selected.
You can adjust the distribution of the center channel
signal, generated through the Dolby Pro Logic II
decoding, to the L/R speakers.
x DIMENSION
(Dimension control)
Initial setting: midpoint (0)
Lets you perform further adjustments for Dolby Pro
Logic II Music mode decoding (PLII MUSIC). You
can set this parameter only when “2CH MODE” is set
to “PLII MUSIC” (page 38) and NORMAL
SURROUND is selected.
You can adjust the difference between the front
channels and the surround channels.