Sub-Zero ICBCT15G - Manual (Page 12)

12
W O L F G A S C O O K T O P U S E & C A R E
C O N T I N U O U S G R AT E S
The continuous low-profile cast iron grates of
your gas cooktop are designed for a close fit.
This enables you to move pans easily from
one burner to another without having to lift the
pan or have it tip over between the grates.
Each grate sets securely on dimples on each
corner of the burner pan. Refer to the illustra-
tion below.
For the 762 mm and 914 mm gas cooktops, the
continuous grates are interchangeable with
each other, with the exception of the single
grate on the 914 mm cooktop.
Illuminated
Control Panel
Control panel for Model ICBCT36G
Continuous Grate
Burner Pan
Grate Feet
Continuous grates
I L L U M I N A T E D C O N T R O L PA N E L
The control panel of your gas cooktop is illumi-
nated for instant visual indication that any one
or more burners are in use. It is a safety signal
reminding you that a flame is on and active.
The illustration below shows the control panel
of the 914 mm gas cooktop.
C O N T R O L K N O B S
Each control knob is positioned to correspond
to the burner regulated.
For the 381 mm and 914 mm cooktops, the
knob on the lower left side regulates the lower
left burner. Conversely, the knob on the upper
right side regulates the upper right burner. The
illustration below shows the configuration of
the control knobs for the 914 mm gas cooktop.
Each knob on the 762 mm cooktop control
panel has a diagram above it. The diagram
shows which burner it regulates.
It is normal for the knobs to be slightly raised
above the surface. This space is an air inlet
necessary for good combustion of gas. Each
knob rests on a valve stem with a rubber
grommet at the base. This design prevents
liquid spills from dripping into the controls
below the burners.