Siemens WFXD5202UC - Manual (Page 20)

20
Washing
q Turn on the water taps.
q Turn the program selector to the
desired program.
q
Load the washing machine and
close the door.
The
start/pause indicator light
flashes (red).
q If necessary, press the button(s) for
additional option(s).
The indicator light of the selected
button is lit (red).
i If an incorrect combination was
inadvertently selected, the
indicator light of the selected
button is turned off.
q If necessary, change the spin
speed with the spin selection
button until the the desired spin
speed indicator light is lit.
q If necessary, change the start
time. Press the delay start button
until the desired start time is
displayed.
q Press the start/pause button.
The indicator light is lit (red).
Display shows the run time of the
selected program. The program
starts.
i Each program step is indicated by
the indicator lights under the
display.
During Washing
i Due to the highly engineered
suspension of this appliance, it
may experience a shudder or
shake when progressing from
lower to higher spin speeds.
This behavior is normal due to
shifting of the drum system and
should not cause concern.
Changing a program
q
Turn the program selector to off.
q Turn the program selector to a
newly selected program.
The start/pause indicator light
flashes.
q If required, change the settings;
see from Page 18.
q Press the start/pause button.
The program starts.
The indicator light is lit.
Add a garment /
Interrupting the program
You can put laundry in the drum after
washing begins, take laundry out of the
drum early or interrupt the program at
any time.
i It is not recommended to add
laundry after the washing phase is
complete.