Sharp MD-X60H - Manual (Page 2)

SPECIAL NOTES
● Recording and playback of any material may require consent, which
SHARP is unable to give. Please refer particularly to the provisions
of the Copyright Act 1956, the Dramatic and Musical Performers
Protection Act 1958, the Performers Protection Acts 1963 and 1972
and to any subsequent statutory enactments and orders.
NOTE FOR USERS IN THE U.K.
SERVICE INFORMATION
In the unlikely event of your equipment requiring repair, please con-
tact the dealer or supplier from whom it was purchased. Where this
is not possible, please contact the telephone number listed below.
You will then be given details of how to obtain service.
- 0345-125387 -
Please note; all calls will be charged at local rate.
Certain replacement parts and accessories may be obtained from
our main parts distributor.
WILLOW VALE ELECTRONICS LTD.
In the unlikely event of this equipment requiring repair during the
guarantee period, you will need to provide proof of the date of pur-
chase to the repairing company.
Please keep your invoice or receipt, which is supplied at the time
of purchase.
The mains lead of this product is fitted with a non-rewireable
(moulded) plug incorporating a 3A fuse. Should the fuse need to be
replaced, a BSI or ASTA approved BS 1362 fuse marked or
and of the same rating as above, which is also indicated on the pin
face of the plug must be used.
Always refit the fuse cover after replacing the fuse. Never use the
plug without the fuse cover fitted.
In the unlikely event of the socket outlet in your home not being
compatible with the plug supplied, cut-off the mains plug and fit an
appropriate type.
DANGER:
The fuse from the cut-off plug should be removed and the cut-off
plug destroyed immediately and disposed of in a safe manner.
Under no circumstances should the cut-off plug be inserted else-
where into a 13A socket outlet as a serious electric shock may
occur.
To fit an appropriate plug to the mains lead, follow the instructions
below:
IMPORTANT:
The wires in the mains lead are coloured in accordance with the
following code:
Blue : Neutral
Brown : Live
As the colours of the wires in the mains lead of this product may
not correspond with the coloured markings identifying the terminals
in your plug, proceed as follows:
● The wire which is coloured blue must be connected to the plug
terminal which is marked N or coloured black.
● The wire which is coloured brown must be connected to the plug
terminal which is marked L or coloured red.
Ensure that neither the brown nor the blue wire is connected to the
earth terminal in your three pin plug.
Before replacing the plug cover, make sure that:
● If the new fitted plug contains a fuse, its value is the same as
that removed from the cut-off plug.
● The cord grip is clamped over the sheath of the mains lead and
not simply over the lead wires.
IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRI-
CIAN.
MANCHESTER 0161-682-1415
READING 01189-876444
● This equipment complies with the requirements of Directives
89/336/EEC and 73/23/EEC as amended by 93/68/EEC.
YO <P=001>
● When the ON/STAND-BY button is set at STAND-BY position, mains
voltage is still present inside the unit.
When the ON/STAND-BY button is set at STAND-BY position and
the clock is displayed, the unit may be brought into operation by
the timer mode or remote control.
Warning:
This unit contains no user serviceable parts. Never remove covers un-
less qualified to do so. This unit contains dangerous voltages, always
remove mains plug from the socket before any service operation and
when not in use for a long period.
MD-X60H(SUK) TINSE0227AWZZ
US and foreign patents licensed from Dolby Laboratories Licensing
Corporation.
CAUTION
Use the MD/CD component system only in accordance with the instruc-
tions given in this manual and do not attempt to interfere with the in-
terlock switch or make any other adjustment as this may result in
exposure to hazardous radiation.
● Dolby noise reduction manufactured under license from Dolby
Laboratories Licensing Corporation.
● "DOLBY" and the double-D symbol G are trademarks of Dolby
Laboratories Licensing Corporation.
1