Sony CDP-XE530 - Manual (Page 13)

Playing CDs
13 GB
Creating a programme using the remote
1
Press PROGRAM before you start playing.
“PROGRAM” appears in the display.
2
Press the number buttons of the tracks you want to
programme in the order you want.
Example: To programme the tracks 2, 8 and 5.
Press the number buttons in the order
2, 8 and 5.
To select a track with a number over 10
Use >10 button (see page 10).
If you’ve made a mistake
Press CLEAR, then press the correct track number.
3
Press · ( or ( for the CDP-XE330) to start
Programme Play.
To cancel Programme Play
Press CONTINUE.
You can check the total playing time while
programming using the remote (Programme Edit)
To select a track, press = or + and check the total
playing time. Then press PROGRAM to confirm your
selection.
Notes
• The total playing time doesn’t appear in the display when it
exceeds 100 minutes.
• If you programme a track numbered over 24 (or 68 for the
CDP-XE330), “– – . – –” appears instead of the total playing
time.
• “PROGRAM FULL” (or “FULL” for the CDP-XE330)
appears in the display when you try to add a track to a
programme which already contains 24 tracks.
Checking the track order
You can check your programme before or after you
start playing.
Press CHECK.
Each time you press this button, the display shows the
track number in the programmed order. After the last
track in the programme, the display shows “- END -”
(or “End” for the CDP-XE330) and returns to the
original display. If you check the order after you start
playing, the display shows only the remaining track
numbers.
Changing the track order
You can change your programme before you start
playing.
To
Erase a track
Erase the last track in the
programme
Add tracks to the end of
the programme
Change the whole
programme completely
You need to
Press CHECK until the track
you don’t want appears in
the display, then press
CLEAR.
Press CLEAR. Each time you
press the button, the last
track will be cleared.
Turn ≠ AMS ± until
the track number you want
to add appears, then push
≠ AMS ±.
When using the remote,
press the number buttons of
the tracks to be added.
Hold down CLEAR until
“CLEAR” (for the CDP-
XE530) or “CLEAr” (for the
CDP-XE330) appears in the
display. Create a new
programme following the
programming procedure.
• CDP-XE530
• CDP-XE330
Number buttons
PROGRAM
CLEAR
CHECK
>10
·
Number buttons
>10
(
PROGRAM
CLEAR
CHECK