Samsung 20041112183630062 - Manual (Page 8)

13 14
The AC Cord must be plugged into an appropriate socket.
Before plugging your system into an AC outlet, you must check the voltage.
1. Plug the AC Cord on the rear of the system into an appropriate outlet.
2. Press the On/Standby button to switch your DVD Player system on.
Connecting your System to the Power Supply Controlling a TV with the Remote
You can operate your TV by adjusting the DVD remote signal .
1
Turn on the TV.
2 Point the DVD’s remote at the TV.
• Manufacturers’ codes are subject to change without notice.
If they are changed, this remote control cannot operate the equipment.
4
If the TV turns off, setup is complete.
• Now, you can perform the following operations on the TV.
3
While holding the button down, enter the
code for your brand.
TV
example : For SAMSUNG 1TVs
While holding down the button,
enter .
TV
Manufacturer
01~06,32
12
12
09,17,21
11,13,14,24
32
02,30
02,16
29
23
13,14,24
08,23~27
02,20,22
13,14,22~24
12,16
02
10,31
15,16
14,24,28
13,14,24,33,34
07,16~19,21
Samsung
Akai
FIisher
Grundig
Hitachi
JVC
LG
Mitsubishi
Mival
Nokia
Nordmende
Panasonic
Philips
Saba
Sanyo
Schneider
Sharp
Sony
Telefunken
Thomson
Toshiba
CODES
• If there is more than one code listed in the table,
enter one at a time to determine which code works.
TV : Turn on or off the TV.
VOLUME +/– : Adjust the volume.
TV/VIDEO : Set the input mode (either TV or VIDEO)
CHANNEL +/– : Change the channels.
Listening on headphones
Listening on headphones
Use headphones (not supplied) for private listening pleasure.
Connect the headphones to the HEADPHONE jack of the front panel.
• No sound is produced from the speakers.
• To prevent hearing damage, do not raise the volume level excessively when using headphones.
HEADPHONE jack