Sony VPL-CS20 - Manual (Page 27)

27
The Installation Menu
A
d
ju
s
tm
e
nt
s an
d Set
tin
g
s
U
s
in
g a M
enu
The Installation Menu
The Installation menu is used for changing the settings of the projector.
Sel: Set: Exit:
Picture
Signal
Function
Setup
Installation
Information
Lamp Mode: Standard
Lens Control: On
IR Receiver: Front & Rear
V Keystone: Auto
Background: Blue
Illumination: On
High Altitude Mode: Off
Tilt
Setting items Functions Initial setting
Tilt... Adjusts the position (height) of the projected picture.
V Keystone Corrects the trapezoidal distortion caused by the projection
angle. Select “Auto” for automatic correction, or “Manual”
for manual correction using the v/V/b/B keys on the
Remote Commander.
When the bottom of the trapezoid is longer than the top
: Sets a lower value.
When the top of the trapezoid is longer than the bottom
: Sets a higher value.
Auto
Background Selects the background color of the screen when no signal
is input to the projector. Select “Black” or “Blue.”
Normally, set to “Blue.” Blue
Lamp Mode Sets the lamp brightness used during the projection.
• High: Illuminates the projected image brightly.
• Standard: Reduces fan noise and power consumption.
The brightness of the projected image will be lower
compared with the “High” setting.
Standard
Lens Control When set to “Off,” the LENS (FOCUS, ZOOM) key on the
Remote Commander, and the FOCUS and ZOOM keys on
the projector do not function. On
IR Receiver Selects the remote control detectors (IR Receiver) on the
front and rear of the projector.
• Front & Rear: Activates both the front and rear
detectors.
• Front: Activates the front detector only.
• Rear: Activates the rear detector only.
Front & Rear
Illumination Selects whether the SONY logo on the rear panel of the
projector lights when the projector is on. On
High Altitude
Mode Set to “On” when the projector is used at an altitude of
1,500 m or higher. Off