Sony VPL-CS20 - Manual (Page 40)

40
Specifications
Specifications
Optical characteristics
Projection system
3 LCD panels, 1 lens, projection
system
LCD panel VPL-CX20: 0.63-inch XGA
panel, approximately 2,360,000
pixels (786,432 pixels
× 3)
VPL-CS20: 0.63-inch SVGA
panel, approximately 1,440,000
pixels (480,000 pixels
× 3)
Lens 1.2 times zoom lens (powered)
f 18.8 to 22.6 mm/F1.6 to 1.94
Lamp 165 W UHP
Projected picture size (measured diagonally)
40 to 300 inches
40 to 150 inches (auto focus
operation range)
Light output ANSI lumen
1)
2000 lm
(When the Lamp Mode is set to
“High.”)
Throwing distance (When placed on the floor.)
40-inch: 1.2 to 1.4 m
(3.8 to 4.6 feet)
80-inch: 2.3 to 2.8 m
(7.6 to 9.4 feet)
100-inch: 2.9 to 3.6 m
(9.6 to 11.7 feet)
150-inch: 4.4 to 5.4 m
(14.4 to 17.6 feet)
200-inch: 5.9 to 7.2 m
(19.4 to 23.6 feet)
250-inch: 7.3 to 9.0 m
(23.9 to 29.5 feet)
300-inch: 8.8 to 10.7 m
(28.9 to 35.1 feet)
There may be a slight difference between the
actual value and the design value shown above.
1)
ANSI lumen is a measuring method described
in American National Standard IT 7.228.
Electrical characteristics
Color system NTSC 3.58 /PAL/SECAM/
NTSC 4.43 /PAL-M/PAL-N/
PAL60 system, switched
automatically/manually
(NTSC 4.43 is the color system used
when playing back a video
recorded in NTSC on a
NTSC
4.43 system VCR.)
Resolution VPL-CX20: 750 horizontal TV
lines (Video input)
1,024
× 768 dots (RGB input)
VPL-CS20: 600 horizontal TV
lines (Video input)
800
× 600 dots (RGB input)
Acceptable computer signals
1)
fH: 19 to 92 kHz
fV: 48 to 92 Hz
(Maximum input signal resolution:
SXGA+ 1400
× 1050
fV: 60 Hz
1)
Set the resolution and the frequency of the
signal of the connected computer within the
range of acceptable preset signals of the
projector.
Applicable video signals
15 k RGB/Component 50/60 Hz,
Progressive component 50/60
Hz, DTV (480/60I, 575/50I,
480/60P, 575/50P, 720/60P, 720/
50P, 1080/60I, 1080/50I),
Composite video, Y/C video
Speaker Monaural speaker system, 40
× 20
mm (1
5
/ 8
× 13
/ 16
inches)
Speaker output
1 W (max.)
Input/Output
INPUT A HD D-sub15-pin (female)
Analog RGB/component:
R/R-Y: 0.7 Vp-p ±2 dB
(75 ohms terminated)
G: 0.7 Vp-p ±2 dB
(75 ohms terminated)
G with sync/Y: 1 Vp-p ±2 dB
sync negative
(75 ohms terminated)
B/B-Y: 0.7 Vp-p ±2 dB
(75 ohms terminated)
SYNC/HD: Composite sync input:
TTL level, positive/negative
Horizontal sync input: TTL level
Positive/negative VD: Vertical
sync input: TTL level, positive/
negative
AUDIO/VIDEO
VIDEO: Composite video: 1 Vp-p
±2 dB sync negative (75 ohms
terminated)
S VIDEO: Y/C (luminance): 1
Vp-p ±2 dB sync negative (75
ohms terminated)
C (chrominance): burst
0.286 Vp-p ±2 dB (NTSC)
(75 ohms terminated),
burst 0.3 Vp-p ±2 dB (PAL)
(75 ohms terminated)
AUDIO: rated input 500 mVrms,
input impedance 47 kilohms