User instructions – Smeg DI912 User Manual
Page 30
User instructions
65
GENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT
MAINTENANCE:
x
The filters should be cleaned under running water using a stiff
brush.
x
It is essential to thoroughly clean the filters according to the above
instructions: the dishwasher cannot function if the filters are clogged.
x
Carefully replace the filters in their seats, to avoid damaging the
wash pump.
PROLONGED DISUSE:
x
Run the soak program twice in succession.
x
Unplug the power cord from the socket.
x
Leave the door slightly open, in order to prevent the formation of
unpleasant odours inside the washing tank.
x
Fill the rinse aid dispenser.
x
Shut off the water supply tap.
BEFORE STARTING THE DISHWASHER AFTER PROLONGED
DISUSE:
x
Check that there are no deposits of sludge or rust inside the water
pipe: if there are, allow the water to run from the water supply tap for a
few minutes.
x
Plug the power cord back into the socket.
x
Reconnect the water intake hose and open the tap again.
TROUBLESHOOTING MINOR PROBLEMS
In some cases it is possible to remedy minor problems by referring to the
following instructions:
If the program fails to start, check that:
x
the dishwasher is connected to the electrical power supply;
x
there is no power failure;
x
the water tap is open;
x
the dishwasher door is properly closed.
If water remains inside the dishwasher, check that:
x
the drain hose is not kinked;
x
the drain siphon is not obstructed;
x
the dishwasher filters are not clogged.