Installation instructions – Smeg DI912 User Manual

Page 7

Advertising
background image

Installation instructions

42

2.1 Water supply connection

Preventing the risk of clogging or damage: if the water pipe is new or has
not been used for a long time, before connecting to the water supply check
that the water is clear and free of impurities, to prevent damage to the
appliance. The dishwasher must always be connected to the water
system with new hoses; old or used hoses must never be reused.

CONNECTING TO THE WATER SUPPLY
Connect the intake hose to a cold water supply with ¾” gas
thread, inserting the filter A supplied with the dishwasher.
Take care to screw the hose firmly into place with your
hands and then complete by tightening about ¼ of a turn
with pliers.

In dishwashers equipped with the ACQUASTOP device,
the filters is already fitted inside the threaded ring.

DRAIN CONNECTION

Fit the drain hose into a pipe having diameter of at least 4 cm; the
dishwasher is fitted with a special device which allows column installation,
even with the drain pipe below the level of the dishwasher.

2.2 Electrical connection and precautions

CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH
THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON
THE INNER EDGE OF THE DOOR.

THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET
OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN
FORCE.
THE PLUG MUST BE ACCESSIBLE AFTER INSTALLATION.
NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY
LEAD.
IN THE EVENT OF DAMAGE TO THE SUPPLY CORD
, HAVE IT REPLACED
BY THE MANUFACTURER OR AN AUTHORIZED TECHNICAL SERVICE
CENTRE.

DO NOT USE ADAPTORS OR SHUNT CONNECTIONS IN ORDER TO AVOID
THE POSSIBILITY OF OVERHEATING OR BURNING.

Advertising