Socket Mobile 10/100 - Manual (Page 7)

2 | Setup
This chapter explains how to set up and use the 10/100
Ethernet CF Card on a Pocket PCs, Handheld PCs, and
pen tablets running:
- Windows Mobile 5.0
- Windows Mobile 2003/2003SE
- Windows CE 2.11 or 3.0
Setup Summary
STEP 1: Prepare network information.
STEP 2: Install the software.
STEP 3: Enter network settings.
STEP 4: Insert card and connect to LAN port.
OPTIONAL: Use ActiveSync over a Network
OPTIONAL: Use the Control Panel Applet
STEP 1: Prepare Network Information
Contact your network administrator for the network settings. A text-only form
that you can email to your network administrator is available in the Docs folder
in the installation CD and online at:
www.socketcom.com/support/support_ethernet.asp
Does the network support DHCP (Dynamic Host Configuration Protocol) ?
YES. If Yes, then what is the valid range of IP addresses for your network?
_______________________________________________________
NO. If No, then please any of the following IP addresses required by
your network (you may need only some):
(a) Mobile Computer IP address: _____ . _____ . _____ . _____
(b) Subnet Mask: _____ . _____ . _____ . _____
(c) Default Gateway: _____ . _____ . _____ . _____
(d) Primary DNS: _____ . _____ . _____ . _____
(e) Secondary DNS: _____ . _____ . _____ . _____
(f) Primary WINS: _____ . _____ . _____ . _____
(g) Secondary WINS: _____ . _____ . _____ . _____
CHAPTER 2: SETUP | 5