Smeg C9GMXU - Manual (Page 11)

Instructions for the Installer
13
4.2 Instructions for floor mounting (secondary system)
The secondary anti-tip device is to be attached to the floor when it is not possible to install the primary
system. After having positioned and leveled the appliance the bracket has to be anchored to the floor
and engaged in the slots at the rear of the appliance.
NOTE: According to the type of floor, the installer should supply the suitable fastening systems (Type of
screw recommended
3
/
8
”).
1 Assemble the fastening
bracket as shown in the
figure. Join the two parts
without tightening them
too much since there will
be other adjustments to
make.
2 After having positioned
and leveled the
appliance, move the
bracket close to the rear
of the appliance and
anchor it to the floor. The
bracket attachment
should insert into one of
the central slots at the
rear.
3 Lower the bracket attachment until anchoring the
appliance slot, tighten the nuts previously assembled.
The anti-tip device works properly only if the bracket
attachment is securely anchored to the appliance.