Smeg C9GMXU - Manual (Page 9)

Instructions for the Installer
11
4.1 Instructions for wall mounting (primary system)
The anti-tip brackets are to be attached to the rear wall as shown. The height of the bracket location from
the floor is determined after the range legs have been adjusted to the installation height as shown in the
installation instructions and the range has been leveled.
1 Level the range
using the
adjustable
leveling legs.
2 From the floor,
measure the
height of the
notch found on
the bracket. This
notch
corresponds to
the centerline of
the holes for the
screws that will
fasten the brackets to the wall.
3 Attach the two anti-tip brackets to the wall using an appropriate fastener (for example, screws
appropriate for the type of the wall). Adhere scrupulously to the heights indicated in the figure (A)
using the appliance’s dimensions as a guide. (Type of screw recommended
1
/
4
” ).
C9GMXU ( 35
3
/
4
” - 908 mm)
A)