Samsung SID-500 - Manual (Page 7)

Overview
COLOR CCD CAMERA User’s Manual 13 COLOR CCD CAMERA User’s Manual 12
Pan Base
control panning angle of camera
Rotate Base Holding Screw
fix rotated position
Rotate Base
control rotating angle of camera
Pan Base Holding Screws (Color : Silver)
fix panned position
Auto Focus 10x ZOOM Lens Module.
SET button
To access the main setup menu. Pressing the “SET” button locks the zoom control
functions of these buttons and prompts the main setup menu.
RIGHT (F-FAR button)
To move the arrow indicator to right. (To see a far object clearly)
LEFT (F-NEAR button)
To move the arrow indicator to left. (To see a near object clearly)
UP (WIDE button)
To move the arrow indicator to up.(To widen the view : ZOOM OUT)
DOWN (TELE button)
To move the arrow indicator to down (To close in on a far object: ZOOM IN)
AF button
To activate auto focus just once.
Video Output Terminal to Monitor
RS-485 Control Cable : The detailed description refers to p18
Power Input Jack
Video Output Jack
Dome Cover
Shield Case
• The zoom postion is saved after 5 seconds when you set zoom function.
Notes
Installation
Installation
1) Remove the dome cover and shield case from the main body by loosening the
three dome cover screws.
2) And then remove the main body from mounting bracket by the four main
body screws.
• The installation should be done by qualified service personnel or sysytem installers.
• If the ceiling material is not strong enough to hold the installation screws, the camera may
fall off. Reinforce the ceiling as needed.
Notes
Locking direction
(Clockwise)
Latch
Locking direction
[Figure-1]
Mounting Bracket
Main Body
(Camera)
Shield Case
Dome cover
Unlocking direction
(Counterclockwise)
* To install the dome cover on the camera
body, turn the latches in locking direction
as shown in the figure 1.