Philips Saeco Presso SUP021YTDR - Manual (Page 17)

ENGLISH
17 PROGRAMMING MACHINE FUNCTIONS
DESCALING *
SIGNAL.DESCAL.
DESCALING
FILL WATERTANK
DESCALING
FILL WATERTANK
TIMER *
RINSING CYCLE
STANDBY
AFTER 3:00
STANDBY
AFTER 1:15
RINSING CYCLE *
FACTOR.SETTINGS
RINSING CYCLE FILL WATERTANK
RINSING CYCLE
TIMER
DESCALING
The machine will carry out
a rinsing cycle.
When the cycle is finished
the FILL WATER TANK
message will be displayed.
This function is used to rinse all the coffee-dispensing parts
with water.
The rinsing cycle cannot be interrupted.
A person must be present during this operation.
Use the buttons to adjust
the timer setting.
The switch-off time can be adjusted, in 15-minute intervals,
to a minimum of 15 minutes; the function cannot be
deactivated.
Prepare the machine for
descaling.
This function enables you to activate an automatic
descaling cycle. See page 10 for step by step descaling
instructions.
Warning: a large quantity of water may be
dispensed from the coffee dispenser. Before
starting, empty out the drip tray and keep an additional
container handy.
When the function ap-
pears, select it using the
“M” button.
When the function ap-
pears, select it using the
“M” button.
When the function ap-
pears, select it using the
“M” button.
Carry out an automatic
descaling cycle (see page
10) or press "ESC" to exit if
descaling is not yet needed.
Press the “M” button to
confirm your choice.
This is a factory-set function that automatically switches
the machine into “Standby” after a maximum of 3 hours
have elapsed since the last cup of coffee was dispensed.