Sierra Wireless 350 - Manual (Page 4)

Portions of this product are covered by some or all of the following US
patents: 5515013, 5617106, 5629960, 5682602, 5748449, 5845216, 5845553,
5878234, 5890057, and other patents pending.
©1998, 1999 Sierra Wireless, Inc. All rights reserved.
The information in this manual is subject to change without notice and does
not represent a commitment on the part of Sierra Wireless, Inc. Sierra
Wireless, Inc. shall not be liable for incidental or consequential damages
resulting from the furnishing, performance, or use of this manual.
AirBooster™ is a trademark of Sierra Wireless, Inc.
AirCard
® is a registered trademark of Sierra Wireless, Inc.
All other brand or product names, logos, trademarks, etc. mentioned in this
manual are owned by their respective companies.
o Welcome (top)
o Overview
o Safety Notices
o Specifications
o
RF Amplifier
o Environmental
o DB-9 Pinouts
Technical Specifications
AirBooster 350 RF Amplifier
Compliance: CDPD Release 1.1
FCC Parts
15 and 22
Voltage: Standard vehicle battery
11 - 16 Vdc (13.8 Vdc nominal)
Current: Power Reduction Mode: 105mA (typical)
Enabled (Receive): 128mA (287mA w/GPS)
Maximum Transmit: 1.63A (1.8A w/GPS)
Transmitter Power: Class I mobile
Up to 4.5 Watts ERP from device
(depending on
antenna/cabling )
CDPD Device Interface: SMA RF connector
Antenna Interface: 50 ohm TNC RF connector
GPS Interface: DB-9 at RS-232 level
non-standard
pinouts .
GPS Antenna Interface: SMB RF connector
Environmental Specifications
Operating Temp: -30 to +70° C (restricted duty cycle)
-30 to +60° C (un-restriced duty cycle)
Storage Temp: -40 to +80° C
Humidity: 5 - 95%, non-condensing
Vibration: MIL-STD-810E,I-3.4.9.
GPS DB-9 Connector Pinouts
Pin # RS-232 AirBooster Application
1 DCD 1 Pulse/sec output from GPS module
2 RxD RxD (from GPS to host)
3 TxD TxD (from host to GPS)