Servis-Rhino TURBO120 - Manual (Page 169)

MAINTENANCE
Turbo 120 01/11 Maintenance Section 5-9
©2011 Alamo Group
MAINTENANCE
DRIVELINES
Many of the equipment components are HEAVY (70 lbs or greater) and Special Lifting
Procedures are recommended. Use lifting assistance such as mechanical assistance, two
people, and proper lifting techniques when connecting or installing the driveshaft to reduce
the possibility of back injuries.
The Drivelines and U-Joints should be inspected each morning before the mower is started.
The U-Joint and CV Joint on the Driveline undergo extreme forces when the unit is turning or when the Wings
are being raised. It is important that the U-Joints and CV Joint be greased per schedule before the unit is
started. The U-Joints are located at each end of the Center and Wing Drivelines. The CV Joint is located at the
end of the Main Driveline. The U-Joint and CV Joint assemblies are accessible by rotating the Driveline Safety
Shield until the hole in the Shield matches up with the Grease Fitting. Lubricate all fittings with a good quality
Lithium Soap compatible E.P. grease meeting the N.L.G.I. #2 specifications and containing no more than 1%
Molybdenum Disulfide. An E.P. grease meeting the N.L.G.I. #2 specifications and containing 3% Molybdenum
Disulfide may be substituted in the telescoping members only. Inspect the U-Joint for wear by holding the shaft
on one side of the U-Joint while trying to rotate the shaft on the other side of the U-Joint. If there is noticeable
movement in the Driveline replace the U-Joint before it causes severe damage to the Driveline.