Servis-Rhino TURBO120 - Manual (Page 173)

MAINTENANCE
Turbo 120 01/11 Maintenance Section 5-13
©2011 Alamo Group
MAINTENANCE
DRIVELINE TAPER CONE YOKE REMOVAL INSTRUCTIONS
1. Loosen 11/16” bolt end one revolution.
2. Insert drift punch (max. diameter 0.375) into hole
opposite the hex head and impact with hammer.
3. Repeat operations 1 & 2.
4. Remove clamping cone from yoke and yoke from
shaft.
NOTE: The clamping cone is serviced only as a
complete assembly. Do not attempt to disassemble the
clamping cone.