Samsung SCC-C7435(P) - Manual (Page 10)

9 0
❚ Before installation
THINGS TO KEEP IN MIND DURING INSTALLATION AND USE
• Do not disassemble the camera on your own.
• Always be careful when handling the camera. Do not strike the camera by your fists or shake
it. Please be careful not to be careless when storing and operating it.
• Do not place or operate the camera in any wet environment such as rain or wet surfaces.
• Do not clean the camera with rough sandpaper. Please always use a dry cloth when cleaning it.
• Put the camera in a cool area free from direct sunlight. Otherwise, the camera may be damaged.
• Power adaptor: 24V AC, �.0A
• If the camera is installed or rebooted after a power failure under �2°F temperature condition, frost
may appear on the DOME cover. Also, PTZ initial error and bad image quality may be displayed
under 14�F. 14�F..
• After the problems, the recovery will be performed as following:
(Conditions: No wind and under -49°F temperature which is guaranteed the normal operation) °F temperature which is guaranteed the normal operation) temperature which is guaranteed the normal operation)
1 It is possible to defrost the DOME cover within 3 hours after the power on.
2 For PTZ initial error, reboot will be executed every 10 minutes and the camera will work normally
within 3 hours after the power on.
※  If PTZ error occurs after the initial boot, the message shown below will be displayed.
"WARMING UP NOW...", "PLEASE WAIT 10 MINUTES."
� For bad image quality, the camera will work normally within � hours after the power on.
❚ Initial setting
Setting up the Address of Smartdome
For the Address Setup of Smartdome, use “SW902”, “SW90�”, and “SW904”.
You can set the address from 0 to 255. Set up the address digit for 100 with “SW902”, for 10
with “SW90�”, for 1 with “SW904”.
For example, if the camera address is “1”, you can setup as follows.
Installation
SW902 SW903 SW904
SCC-C7433_7435-Eng.indd9 2008-05-20오전10:49:36