Samsung SCC-C7435(P) - Manual (Page 26)

 6
. Push the connected cables into the inside of the Rod Coupling. At the same time, insert the
Holder Housing into the Rod Coupling while fitting the Guide of the Holder Housing into the
Guide Hole of the Rod Coupling. Then, turn the Holder Housing clockwise by approximately
18 degrees. Finally, secure the Holder Housing to the Rod Coupling using the � Screws
(M4xL8, fitting).
- Install the Holder Housing so that the FRONT label faces the front of the camera to be installed.
- Make sure that the Bush Cable should not be loose from the Holder Housing.
(If the Bush Cable is not secured firmly, the product is not properly waterproof.)
ROD COUPLING
HOLDER
HOUSING
ROD
COUPLING
ROD
COUPLING
HOLDER
HOUSING
GUIDE HOLE
HOLDER
HOUSING
SCREW
GUIDE
BUSH CABLE
SCC-C7433_7435-Eng.indd25 2008-05-20오전10:49:41