Smeg CR321A - Manual (Page 5)

Instructions for Use 61
Placing and Installation
Choosing the Right Place
Place the appliance in a dry and regulariy ventilated room. Allowed
ambient temperature depends on the model (class) of the appliance
and is stated on the rating plate of the appliance.
Class Ambient temparature
SN (sub-normal) from + 10°C to + 32°C
N (normal) from + 16°C to + 32°C
ST (sub-tropical) from + 18°C to + 38°C
T (tropical) from + 18°C to + 43°C
Never place the appliance near heat emitting devices (e.g. cooker,
radiator, water heater or similar devices) and do not expose it to direct
sunlight.
The appliance should be positioned at least 3 cm away from the
electric or gas cooker and at least 30 cm away from the oil or coal
stove. If this is not possible, use an appropriate insulation.
Behind the appliance there should be free space at least 200 cm² wide
and above the appliance the high kitchen units should be at least 5 cm
away from the appliance in order to assure adequate ventilation of the
condenser unit.
Connection to Power Supply
Connect the appliance with the cable and plug to the power supply
socket outlet with a ground terminal (safety socket).
Required nominal voltage and frequency are indicated on the rating
plate.
The connection to the mains supply and earthing have to be made
according to current standards and regulations. The appliance resists
temporary voltage tolerance up to -15 to +10 %.