Swiss Diamond IP10S - Manual (Page 5)

IP10S / IP10 user guide 4 02P182000Aen
For your safety
Connection
Plug the telephone’s connecting cables into the appropriate sockets only. Never try to change the
plugs on the connecting cables.
Only a Swissvoice power adaptor must be used with the IP10S and IP10 phones.
Swissvoice power adaptor references are:
For US: 02P175500A
For Europe: 20314471, 02P175600A
For UK: 02P183100A
For Australia: 02P183200A
Use of a third party power adaptor would be improper. Consequently, in case of product defect or flaw
caused by this improper use, the guarantee will not apply.
Security
The plug-in power supply is used as a disconnection device.
The network and power supply accesses of the phone are classified SELV (Safety Extra Low Voltage).
The mains access of the plug-in power supply is classified Dangerous voltage.
Care
Never carry the telephone by its connecting cord.
Clean the set with a soft, slightly damp or anti-static cloth. Do not use any detergents or chemicals to
clean the set.
Qualified service
Do not attempt to open the phone. Only qualified personnel may repair phone equipment. Changes or
modifications not expressly approved by Swissvoice could void the user’s authority to operate the
equipment. If your telephone is faulty or defective, please contact your supplier.
Information regarding the products in this manual is subject to change without notice. This guide is
believed to be accurate but is presented without warranty of any kind, express or implied. The usable
services and features on the phone depend on the installed software release and on the call manager.
Therefore, the conformity of the user guide cannot be guaranteed.