Swiss Diamond IP10S - Manual (Page 11)

IP10S / IP10 user guide 10 02P182000Aen
Getting started
Package contents
1 telephone set
1 handset
1 spiral handset connecting cable
1 Ethernet cable (100 base T)
1 wall mounting kit
1 short operating instruction (A5 paper sheet)
1 non-printed sticker for feature keys (version B only)
Separately delivered:
1 power supply.
Not included:
An additional Ethernet cable to connect any PC to the telephone through its PC-switch.
Installation
Your IP phone is designed to be connected to an Ethernet IP (Internet Protocol) network. Its
connection to the network has to be done by your system administrator. If that is not the case, follow
the above instruction for connecting your phone, and then ask to your system administrator for its
configuring.
Connecting the handset: insert the straight end of the spiral connecting cable into the socket on
the base of the telephone (1). By gently pulling, check that the cable connector is in place. Insert the
other end of the cable into the handset (2).
You may use a headset instead of the handset.
Powering the telephone*: insert the power cable jack into the socket (3) and plug the other end in
a standard power outlet (4). Swissvoice is displayed a few seconds followed by Waiting for call
manager…
If your system administrator delivered your phone without a power supply, your phone probably
receives power through the Ethernet connection.
Connecting to the local area network: insert the Ethernet cable connector into the "LAN" socket at
the bottom of the terminal (5). By gently pulling, check that the cable connector is in place. Insert the
other end of the cable into the LAN connection socket (6).
Shared network connection: This capability is offered on the IP10S model. If you have a single
Ethernet port in your workspace with your desktop computer already connected to it, disconnect the
Ethernet cable from the computer and attach it to the "LAN" port on the back of your phone (5). Next,
use the Ethernet cable included with your phone to connect the "PC" port (7) on the back of your
phone to your desktop computer (8). The IP10S phone has an integral switch.
* Only a Swissvoice power adaptor must be used. For references, see "Connection" page 4.