Logging handsets onto a telephone system – Siemens Gigaset 3000 User Manual
Page 22
22
Logging handsets onto a telephone system
●
Open the logon window with the second telephone.
An "Optiset E" Hicom telephone is used here by way of
example to demonstrate the procedure:
●
Take your handset and log it on to the system
(see page 23).
*
The display may differ slightly depending on the telephone used as Optiset de-
vices support 24 characters and handsets 16 characters.
e.g.
... Enter the code for activating the code
no. e.g. "
O
24".
An
input prompt
appears.
*
e.g.
...
Enter the assigned handset call
number, e.g. "45678".
For network-wide code no.: terminate
code no. with "#".
An
input prompt
appears.
e.g.
... Enter the handset code no. (PIN E1),
for example, "13579".
Stars
O
are displayed instead of dig-
its.
For network-wide code no.: terminate
code no. with "#".
e.g.
The handset call number is displayed.
e.g.
... Confirm the displayed handset
number by re-entering it, e.g. "45678".
Do not terminate with "#".
The ring tone sounds briefly. The log-
on window opens for 10 minutes when
the ring tone is no longer audible.
Note:
The logon window is automatically closed if the handset
is not logged on as described above within 10 minutes. In
this case, you must repeat the procedure.
)!,
- *))*N
)!,7
7!)!,!