Stewart Filmscreen Corp CM-1005 - Manual (Page 11)

Connecting the Video Interface Control System (VICS)
The 12V VICS enables up and down operation of the screen in conjunction
with a projector, tuner, VCR, cable box, or switched AC outlet.
Preparing the connection
Before making the electrical connections, you need:
‹ An available AC constant power source
‹ A 4-conductor cable (14ga)
Making the connection
Figure 7 illustrates the connection.
1. Feed the cable with the pigtail back into the screen case through
the romex connector.
2. Feed one end of a length of a 4-conductor cable (14ga) through
the same connector as in step 1.
3. Connect the 4-conductor cable to the pigtail inside the unit.
4. Use a screwdriver to open the VICS unit.
5. Feed the other end of the 4-conductor cable through the romex
connector on the VICS unit.
6. Connect wires to the terminal block.
7. Secure the clamp on the romex connector.
8. Replace the cover on the VICS.
9. Plug the AC power cord of the VICS into the AC outlet.
10. Attach the 12V trigger wire to the jack in the VICS.
Visionary Electriscreen: Owner’s Manual 9
Figure 7: VICS connection
To AC Power Source
Romex Connector
4-Conductor Cable (14ga Recommended)
Terminal Block
12V Trigger Wire to Projector
LED
Romex
Connector