Stewart Filmscreen Corp CM-1005 - Manual (Page 7)

The motor requires standard AC input (unless an alternate voltage has been
specified). All connections are made to the electrical box on the side of the
unit (audience left).
There are several switch controls available. Follow the installation
procedure for the type of switch control you will install.
General suggestions for wiring:
‹ Soldering is recommended.
‹ The use of wire nuts is acceptable.
Refer to Figure 3 for an illustration of the electrical connection on the side of
the screen unit.
Visionary Electriscreen: Owner’s Manual 5
S
TEP
2. E
LECTRICAL
H
OOK
-
UP
Caution
Professional techniques need to used when making any
electrical connection. A qualified electrician should perform
these procedures.
Be sure to follow all standard safety procedures for
installing electrical devices.
Do not disassemble or alter the configuration of the motor
or the unit's electrical connections. This may cause injury to
you or damage to the product.
The electrical connection should be made only to the type
of power source indicated on the marking label.
Figure 3: Electrical connection
Electrical
Connection
Screen
Romex
Connector