Smeg LBS 635 - Manual (Page 12)

12 12
EN
Adding laundry
If you want to add laundry to your machine
after program begins press Start/Pause
key for switching machine to pause mode.
If water level in the machine is appropriate
“door” led on program progress display
is on and laundry can be added to the
machine. If “door” led is not on after one
minute than water level in the machine is
not appropriate and laundry can not be
added. You can press “Start/Pause/Can-
cel” key for continuing program.
Cancelling a program
For canceling a program “Start/Pause/
Cancel” key is pressed for three seconds.
After this period “Start/Pause/Cancel” and
all other leds will be off .You can select a
new program and start washing.
If cancel task is performed during washing
“Spin” led on display will light on, machine
will pump and when “Spin” led is off “door”
led will be on, door can be opened and
new program can be selected.
After machine starts operation even if spin
speed or washing temperature is changed,
initial speed and temperature is valid. In or-
der to change spin speed or temperature
after pressing “Start/Pause/Cancel” new
cycle or temperature can be selected.
End of the Program
When program ends “ door” led will light
on and door can be opened and machine
is ready for next washing. Press “On/Off”
for turning machine off.
Emptying Laundry
After program ends machine automati-
cally stops. Turn off tap water. Pull the
handle and open loading door. Turn off
your machine by pressing “On/Off”. After
taking laundry out keep the loading door
open and let the drum ventilate. Check the
bellow and clean.
Changing Program
You can use this feature for washing
laundry in the same textile group for wash-
ing at lower or higher temperatures. For
example, instead of Cotton60, Cotton40
can be used. For selecting Cotton40
instead of Cotton60 by pressing “Start/
Pause/Cancel” key machine is switched to
pause position. Program knob is turned for
selecting Cotton40 program.
Even when the program selection knob
is changed during the program initially
selected program will be executed. For
changing washing program continuing
program must be cancelled.
Although selected auxillary functions must
be compatible with washing program.