Smeg LBS 635 - Manual (Page 5)

5
EN
Warnings
• This product is designed for home use.
• Your washing machine is adjusted to
230V.
• If the fuse in your house is less than
16A than have a certified electrician
deploy an 16A fuse.
• In case of transformer or non-trans-
former use, grounding installation must
be performed with a licensed electri-
cian. Any use before grounding is not
our responsibility.
• Never place your machine over a car-
pet covered floor. Otherwise electrical
parts of your machine may overheat.
This may cause malfunction of your
machine.
• Make sure hot and cold taps are
connected correctly. Otherwise your
laundry may come out hot and torn .
• Please call certified service for a failure
of electric plug / cable.
• Be careful about your water hoses are
not old. Do not use old / torn water
hoses. This may cause stain in your
laundry .
• At first use, washing must be per-
formed at Cotton 90°C program
without loading with laundry for getting
your machine ready for washing.
• Performance of your washing machine
depends on the quality of water and
hygiene compound used. If low quality
and unfitting cleaning material is used
the stains will be fixed. Before wash-
ing your laundry with stain keep your
attention on cleaning the laundry as
explained in following pages.
• This is period of keeping spare parts
for your machine to operate. Because
of quality control procedures there
might be little amount of water in your
machine. This does not have any dam-
age to your machine.
• Your machine is programmed for
starting operation again when electric-
ity is off and on afterwards. You can
not press On / Off button to cancel
program. Machine will go on program
when electricity is on. To CANCEL the
program press >Start/Pause/Cancel<
button for three seconds. (See. Can-
celling a program)
If “Door” led on program progress dis-
play is blinking program selection knob
is middle position. In this case turn the
knob and adjust it again. If the warning
continues call authorized service.
• After your machine starts operation, if
Start/Pause/Cancel key starts blink-
ing than door is not locked. Open and
close the door again begin washing
program again.
• If the “washing” led on the program
progress display is blinking either there
is no water or tap is off. Check your
taps. Turn your machine off and on.
If the problem persists unplug your
machine, turn off tap water and call
authorized service.
• If program is started and program
selection can not be performed your
machine might be in protection mode
due to infrastructure problem (voltage,
water pressure, etc.) Press and hold
the > Start/Pause/Cancel < button for
3 seconds in order to switch machine
to factory settings.
• Most of the warnings resulting in call-
ing an authorized service are due to
infrastructure problems. For this reason
applying to an Authorized Service is
recommended.