Preparing the phone for service, Install the phone – Siemens W12 User Manual
Page 4
Gigaset 4010 Comfort, CHIN eng, A31008-G4010-C102-1-7619 umschl_v.fm 16.10.03
Preparing the Phone for service
The pack contains
z
Base
z
Handset
z
Rechargeable battery
z
Phone cord
z
Power supply units
z
One set of operating instruction
Install the phone
1. To open the battery compartment, press the battery cover of the handset and
slide it down.
2. Insert the battery plug into the socket in the battery compartment and place
the battery into the battery compartment.
3. Push up the battery cover.
4. Place the handset with batteries into the charger.
5. Raise the antenna.
6. Insert the plug of adapter into the socket on the back of the base, and then
connect the other end into the 220V power supply. It’s in the status of
charging when the LCD light.
Note: For the initial charge we recommend a continuous, uninterrupted charging
period of more than twelve hours before using.
7. After charge, fit the small jack on the phone cord into the socket in the base
and fit the other end into phone outlet.
8. If “Ringer Off” is shown on the display, please set the ringer tone to “ON”
according to the descriptions in the “Ring switch” section.
4