Sony CDP-NW10 - Manual (Page 38)

38 US
Chapter 6 Using the System Network
Talking with Persons in
Other Rooms (INTERCOM)
You can talk with person in any room using the Intercom
function. While INTERCOM is set to ON, the internal
speaker is activated and speakers connected to the Unit
are muted. The streaming on the network stops until the
intercom connection is terminated on both of the sending
and receiving rooms.
1
Press the “INTERCOM” SELECT on the Home Menu.
The Room list appears.
2
Press any SELECT to select the room you want to
contact.
If the room you want to contact is not displayed on the
front panel display, press the “V” SELECT to display
the next page.
The INTERCOM display appears, and connection is
established after the receiving room answers.
3 To cancel the intercom connection, press the “OFF”
SELECT on the Intercom display.
To answer INTERCOM
Press the “ANSWER” SELECT in the receiving room.
Notes
• If there is no answer from the room you are trying to contact,
the connection is terminated automatically in 10 seconds.
• Connection between rooms terminates automatically 30
seconds after the receiving room answers.
• Connection can be terminated by pressing the “OFF” SELECT
from either the sending or receiving room.
• A Unit can call up all the rooms using the INTERCOM
function, but only one room can answer the call. Connections to
rooms other than the answering room are disconnected.
To adjust the speaker level during INTERCOM
The volume of the INTERCOM function is independent
from that in audio control.
Adjust the volume with + VOLUME and – VOLUME on
the Unit while the INTERCOM connection is established.
Excluding a Unit from INTERCOM
(Intercom Privacy)
Any room in which the Intercom Privacy is set to ON,
does not receive the Intercom signal.
1
Press the “V” SELECT on the Home Menu, then
press the “SETUP” SELECT.
The Setup Menu appears.
2
Press the “V” SELECT repeatedly until “INTERCOM
PRIVACY” appears on the front panel display.
3 Press the A or B SELECT to activate Intercom
Privacy mode.
“PRIVACY” is highlighted and the Intercom Privacy is
set to ON.
A B
Press the A or B SELECT to exit the Intercom Privacy.
Changing the call sound of the INTERCOM
You can change the call sound heard when the room
receives an intercom signal.
1
Press the “V” SELECT on the Home Menu, then
press “SETUP” SELECT.
The Setup Menu appears.
2
Press the “V” SELECT repeatedly until “INTERCOM
RING” appears on the front panel display.
3 Press the A or B SELECT to select the sound.
A B