Sony DCR-VX9000 - Manual (Page 66)

66
Audio dubbing
Recording
(1) Set the POWER switch to ON and then set CAMERA/VTR to VTR.
(2) Open the cover, press ·, then ) or 0, to search for the start and end points of
the recording.
(3) Press P at the start point of the recording.
(4) Press AUDIO DUB
.
(5) Adjust the recording volume.
(6) Press P.
Audio dubbing begins.
If you are using an audio source system, press P on the stereo at the same time.
: Signal flow
Audio source
AUDIO
DUB
PAUSE
2
3,
6
4
REW PLAY FF
REC LEVEL
To stop recording
Press π.
To pause recording
Press P. To start recording again, press P.
To adjust the volume
If you set REC LEVEL to AUTO, the volume is automatically adjusted.
To adjust the volume manually, set REC LEVEL to MANU, and turn the REC LEVEL
dials.
To find the end point of a recording when dubbing
Use the time code display. Set ZERO SET MEMORY to the end point of the recording,
and you will be able to see when you have reached the end point.
Note on audio dubbing
You cannot operate audio dubbing on 16 bit recorded tapes.